Meinberg TCR510PCI Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel Meinberg TCR510PCI. Meinberg TCR510PCI User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer

Résumé du contenu

Page 1 - Operating Instruction

TCR510PCITechnical InformationOperating Instruction

Page 2 - Impressum

10Pulse outputsThe module TCR510PCI generates pulses at change of second (PPS) and change ofminute (PPM). The PPS signal is available with TTL (0/+5V)

Page 3 - Table of Contents

11The 9 pin D-Sub-connector is wired to the board’s serial port. Pin assignment canbe seen from the figure above. This port can not be used as serial

Page 4 - Diskette with driver software

12Putting into operationTo achieve correct operation of the board, the following points must be observed.Installing the TCR510PCI in your ComputerEver

Page 5 - Description of IRIG-Codes

13Input impedanceThe IRIG-specification doesn’t define values for the output impedance of generatorsor the input impedance of receivers. This fact led

Page 6 - IRIG-Standard format

14Photocoupler inputPulse width modulated (DC Level Shift) codes are insulated by an onboard photo-coupler. The connection scheme is shown below:The i

Page 7 - AFNOR-Standard format

15Firmware UpdatesWhenever the on-board software must be upgraded or modified, the new firmwarecan be downloaded to the internal flash memory via the

Page 8 - Features TCR510PCI

16Technical specification TCR510PCIRECEIVER INPUT:AM-input (BNC-connector):insulated by a transformerimpedance settable 50 Ω, 600 Ω, 5 kΩinput signal:

Page 9 - Functional description

17OUTPUTS: pulse per second (PPS):TTL- and RS-232 levelpositive pulse, pulse duration 200 msecpulse per minute (PPM):TTL levelpositive pulse, pulse du

Page 10 - Asynchronous serial port

18Format of the Meinberg Standard Time StringThe Meinberg Standard Time String is a sequence of 32 ASCII characters startingwith the STX (start-of-tex

Page 12 - Input signals

ImpressumMeinberg Funkuhren GmbH & Co. KGAuf der Landwehr 22D-31812 Bad PyrmontTelefon: ++49 (0) 52 81 / 9309-0Telefax: ++49 (0) 52 81 / 9309-30In

Page 14 - Configuration of TCR510PCI

Table of ContentsImpressum ... 2Diskette with driver software

Page 15

4Diskette with driver software

Page 16

5IntroductionThe transmission of coded timing signals began to take on widespread importance inthe early 1950´s. Especially the US missile and space p

Page 17 - CE Label

6IRIG-Standard format

Page 18

7AFNOR-Standard format

Page 19

8Features TCR510PCIThe board TCR510PCI was developed for computer systems with PCI-bus. It isdesigned as an universal board and can be used in systems

Page 20

9Functional descriptionAfter the received IRIG code has passed a consistency check, the software clockand the battery backed realtime clock of TCR510P

Commentaires sur ces manuels

Pas de commentaire