Meinberg SyncBox PTPv2 Manuel d'utilisateur télécharger pdf (Page 16)

If there is a DHCP (Dynamic Host Configuration Protocol) server available in your

network, the LANTIME system can obtain its IPv4 settings automatically from this

server. If you want to use this feature (again, you should ask your network

administrator whether this is applicable in your network), you can change the DHCP

Client parameter to “ENABLED”. Using DHCP is the default factory setting.

If the DHCP client has been activated, the automatically obtained parameters are

shown in the appropriate fields (IPv4 address, netmask, gateway).

Configuration: Local

In the Local section you can activate an reboot of the SyncBox and set up a new

password for the only user “root”.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Pas de commentaire

Meinberg SyncBox PTPv2 Manuel d'utilisateur Page 16